What is is an IP address to log in to NETGEAR WiFi Range Extender or router. It is used to set up any model of NETGEAR router and WiFi extenders. If you cannot access extender and router using mywifiext.net login page, use as a web address.

Just launch a web browser and type in the address bar. If this web page doesn’t open or shows an error message, that means there is some technical issue which is preventing your extender from connecting to NETGEAR Extender Setup page. is meant to open NETGEAR Genie Smart Setup Wizard for extender that will work in the same manner as that of mywifiext.net or mywifiext.com. NETGEAR WiFi Range Extenders help in removing dead zones where you get no connectivity in house or office. Extenders are also famous for the name: boosters, expanders and repeaters. The high-speed internet access using NETGEAR Extenders can only be obtained via mywifiext.net or takes too long to respond

Despite the fact that is the easiest way to set up a NETGEAR Range Extender and router, yet it takes too long to open where users get frustrated and exit the browser window immediately.

mywifiext.net setup

But with some patience and following these simple instructions, you may install NETGEAR WiFi extender easily and thus enjoy it’s network in dead zones. While NETGEAR Extender Setup, it is very important to open web page to complete the installation and configuration process. And most of the cases, this web page doesn’t open. This is because it is a private IP address and used only within private networks. cannot be accessed from external networks.

Use mywifiext.net web address instead of to set up a new extender and change settings to match your requirements.

Different ways to reach for New Extender Setup

Try using the following methods to resolve ‘ takes too long to respond’ issue:

  • Cross-check the IP address you entered
  • Type either www.mywifiext.net or www.mywifiext.com
  • Connect to extender’s network
  • Apply proper power supply to extender
  • Close all extra opened tabs in web browser
  • Go to default NETGEAR admin interface
  • Use username and password
  • Carefully log in
  • Connect extender to internet
  • Switch to a different web browser

Still facing the same issue after following the above steps, contact the expert technicians at Toll Free 1-844-697-8376.


NETGEAR Extender Setup through

Want to set up NETGEAR WiFi Range Extender using Here are the instructions to follow carefully:

  • Turn on the extender by plugging it into a wall socket.
  • On PC or laptop having a fast internet speed, launch any of available web browsers.
  • In the address bar at top side, type IP address.
  • Once done, press Enter on keyboard.
  • A login page will appear. If you already have an account, enter login credentials. If not, create an account with your email and password as ‘password’.
  • Choose available router network.
  • It will ask for password. Enter it and click Continue.
  • Make a wireless connection between extender network and WiFi devices.
  • At last, complete the process by hitting Finish button.
  • In case there are four green lights on extender, it means the extender has been set up successfully. If not then call 1-844-697-8376 and get help from technicians to set it up within minutes.

Configure NETGEAR WiFi Range Extender via

To configure NETGEAR Extender through, follow the step-by-step guide given below:

Place the extender and apply power. After that, connect to an existing wireless network. On any web browser, go to address. Log in using default credentials which can be found on manual. Post that, a web page will appear which allows you to configure NETGEAR Extender in a few moments. From here, extender settings can be customized, router firmware can be updated, a secure network can be created and a lot more. To get assistance for any type of issue, feel free to get in touch with experts at Toll Free number 1-844-697-8376.